COSTUM MADE WOOD SECTIONAL GARAGE DOOR

SEMI CUSTOM SPECIFICATIONS

 

2 Layer Door

Paint Grade (primed white)

  • Back (layer 1): ¼” Luan
  • Frame (layer 2): 1-3/8” FJ (Finger Joint) Hem Fir Deep Plowed
  • Insulation: ½” Polystyrene is optional and considered an upgrade.
  • Panels (Option 1): 3/8” Baltic Birch recessed panels available with or without V-Grooves.
  • Panels (Option 2): ½” Extira raised panels (Considered upgrade, additional charges may apply)
  • Stiles: Double center stiles with V-Groove

Stain Grade (unfinished)

  • Back (layer 1): ¼” Luan
  • Frame (layer 2): 1-3/8” Clear Western Hemlock Deep Plowed
  • Insulation: ½” Polystyrene is optional and considered an upgrade.
  • Panels (Option 1): 3/8” Aquatek Marine Ply recessed panels available with or without V-Grooves.
  • Panels (Option 2): 5/8” Hemlock raised panels (Considered upgrade, additional charges may apply)
  • Stiles: Double center stiles with V-Groove

 

Finish

  • Paint Grade: Comes primed white with 1 coat of exterior grade water based primer
  • Stain Grade: Comes unfinished and requires sanding prior to finishing. (Finishing is required to be completed within 72 hours of installation)  

Track   

  • All 2″ tracks are 12″ or 15″ Radius – 14 gauge horizontals with 17 gauge verticals
  • All tracks are mounted with reverse continuous jamb angle
  • Horizontals are reinforced with 13 gauge angle mounted continuous to the length of the horizontal
  • All 3″ tracks are 15″ Radius – 12 gauge and use is determined by weight of door
  • Options: Low Headroom (0″ or 3.5″ ), High Lift, Vertical Lift, Follow the Pitch    

Hardware

    • All components are galvanized steel and consist of 11 gauge hinges, 12 gauge top & bottom fixtures
    • 2″ nylon 10 ball bearing rollers with long-stem for top & bottom fixtures and short-stem for hinges
    • Inside lock included.

  *Please Note: 3″ steel 10 ball bearing rollers will be used when specified.

Counterbalance

  • Springs are oil tempered and calibrated per door weight, size and track requirements
  • Standard springs are 10,000 cycle
  • 25k, 50k, 100k cycle springs are available with an additional cost
  • 12 guage bearing & spring plates
  • 16 gauge torsion tube is standard, 14 gauge, 11 gauge and solid shafts are available and used when specified

Struts

  •  22GA 2-1/4″ galvanized steel struts with every door, 3″ when specified.
  • Quantity is determined by number of sections

Weather Seal

  • 1-3/8″ EPDM bottom seal and nailed in using galvanized nails

Warranty

Limited 1 year warranty against defect in workmanship or material; limited 1 year warranty on hardware and components.

Miscellaneous

    • Putty: All doors are assembled with galvanized staples and filled in with putty except Cedar and Marine Ply
    • Standard Texture is smooth
    • Hand Hewn, Re Sawn, and Wire Brushing are available for additional cost
    • Perimeter Weather Strip (Stop Mold): 11/16”x2-1/4”    

  *Available in all species of wood