Door Frame

  • Material: 1-3/4″ thick extruded 6063-T6 non corrosive commercial-grade
  • Sections: Height of section determined by height of door
  • Top rail width – 4-5/8″
  • Bottom rail width – 4-5/8″
  • Combined intermediate rail widths – 4-1/4″
  • Center stile width – 2-7/8″ End stile width- 4-5/8″
  • Section Joints: Standard tongue & groove
  • Assembly: Stiles are through bolted to the rails added rigidity and strength
  • Maximum door width: 18ft            
  • Maximum door height: 14ft.


  • Aluminum is sent through a chemical process that leaves it with an extremely durable anodizing finish


    • Glass Size Capabilities: Three options of glass thickness available 1/8″ / 1/4″ / 1/2″
    • Standard Options: Clear Tempered / Frosted Tempered / White Laminate
    •   *specialty glass available upon request to match a style of your home             

          *Please Note: All glass is tempered except for laminated options.

  • Glazing is completed using a butyl tape that adheres the glass to the frame and provides a high quality seal
  • Aluminum retainers are snapped in place with a 1/4″ EPDM round foam strip between the glass and aluminum retainer acting as another seal and impact dampener


  • All 2″ tracks are 12″ or 15″ Radius – 14 gauge horizontals with 17 gauge verticals
  • All tracks are mounted with reverse continuous jamb angle
  • Horizontals are reinforced with 13 gauge angle mounted continuous to the length of the horizontal
  • All 3″ tracks are 15″ Radius – 12 gauge and use is determined by weight of door
  • Options: Low Headroom (0″ or 3.5″ ), High Lift, Vertical Lift, Follow the Pitch


  • All components are galvanized steel and consist of 14 gauge hinges, 12 gauge top & bottom fixtures
  • 2″ nylon 10 ball bearing rollers with long-stem for top & bottom fixtures and short-stem for hinges
  • Inside lock included
  •  *Please Note: 11 gauge components and 3″ steel 10 ball bearing rollers will be used when specified.


  • Springs are oil tempered and calibrated per door weight, size and track requirements
  • Standard springs are 10,000 cycle
  • 25k, 50k, 100k cycle springs are available with an additional cost.
  • 12 guage bearing & spring plates
  • 16 gauge torsion tube is standard, 14 gauge, 11 gauge and solid shafts are available and used when specified


  • (2) 22GA 2-1/4″ galvanized steel struts come with every door, 3″ when specified

Weather Seal

  • 4″ bulb type bottom weather-seal is standard, 6″ available at additional cost